1. The document lists the features included with a capacitive relay switch panel, which include a touch screen panel, circuit control box, cable, labels, power cables, output wires, and screws. 2. The panel allows easy control of LED work lights and appliances on vehicles through capacitive touch and includes labels for common boat features. 3. It can handle voltages of 12V or 24V and has a maximum 10A current for each of its 6 output circuits, with overcurrent protection via resettable fuses.

1. Features:
1x Touch Screen Panel
1x Circuit Control Box
1x DB-15 15pin Cable
20x Label Sticker
2x Power Cables (One for V+, another for GND)
6x Output Wire with Quick connectors
2x M4 Screws (For connecting Power Cables)
4x M4 Self-Tapping Screws (For mounting onto surface)
Include following labels:
“Navigation Lights”, “Anchor Light”, “Cabin
Lights”,”Cockpit Lights”, “Inst Light”, “Bilge Pump”,
“Accessories”, “Trim Tabs”, “Instruments”, “Wiper”, “DC
Outlets”, “Fridge”, “Horn”, “VHF”, “Stereo”, “GPS”,
“Depth Sounder”, “Winch”, “Spot Light”, “Freshwater
Pump”, “Bait Tank Pump”, “Blower”, “Deck Wash”,
“Stern Light”, “Spare”, “Aerator”, “Autopilot”, “RADAR”
Capacitive Relay Switch Panel allows you to easy
control LED work lights, and other appliances on your
4WD, Caravan or RV. Capactive Touch Panel is re-
sponsive and easy to operate. One device suits both
12V / 24V Voltage. No matter you use a truck or a
car both would work great. Maximum current for each
output is 10A, protected by PPTC Resettable fuse.
Typical installation:
http://www.batteksystem.com
BATTEKENGINEERING FOR EXCELLENCY
CAPACITIVE RELAY SWITCH PANEL
50mm / 2”
20mm / 0.8”
100mm / 4”
80mm / 3.14”
Mounting Hole Cut Out for Panel
BATTEK
Capacitive Switch Relay Panel
Touch Screen Panel DC 12V/24V
+
BATTERY
+ VGA Socket−
1 2 3 4 5 6
LED Bar Work Light
6 loads connected up to 10A
www.batteksystem.com
+ VGA Socket−
1 2 3 4 5 6
135mm / 5.3”
85mm / 3.3”
30mm / 1.2”
51mm / 2”