1. Session Plan-7 (M01-LO7)
Unit of Competence Set-out Masonry Structures
Module Title Setting-out Masonry Structures
LO7 Clean up
Session Objectives: At the end of this session the trainees shall be able to –
clear work area and dispose reused or recycled
materials in accordance with
legislation/regulations/codes of practice and job
specification
clean, check, maintain and store tools and equipment
in accordance with manufacturers’ recommendations
and standard work practices
Nominal
Activities Contents Methods
Duration
Introduction 10 mins Recapitulation Discussion
Sessions 30 mins Housekeeping and 5S Lecture-discussion
Tools and Equipment Cleaning
20 mins Lecture-discussion
and Maintenance
Concept and Procedures of
Lecture-discussion
30 mins Material Disposal, Recycling
and Demonstration
and Reuse
15 mins Waste Management Lecture-discussion
Evaluation 45 mins Accomplishment of LAP Test Individual Activity
Summary 5 mins Wrap-up and Feedback Question & Answer
Resources Learning Guide #7
Sample materials
Masonry common tools and equipment

2. Evidence Plan
TVET Program:
Learning Outcomes /
Modules covered
Batch Class
Ways in which evidence will be collected:
Demonstration
Knowledge
Questioning
LAP Test
with Oral
Test
The evidence must show that the student……
*Critical aspect of competence
Prepared by: Date:
Checked by: Date:

3. Session Plan ____
Unit of Competence : perform minor maintenance
Module Title : minor maintenance
LO 01_ : prepare for minor maintenance
Session Objectives: At the end of this session the learners shall be able to –
Identification, selection and provision of tools,suppliesandmaterials
for maintenanceonsite accordingtosupervisor'sinstructions
Regularoperationalchecksofmachineryand equipment
Identification and segregation of faulty or unsafe machine/equipment for
repair/replacement according toenterpriserequirements
Identification of Faultyor unsafemachineryandequipment for repair or
replacement accordingto enterpriserequirements
Identification of OHS hazards intheworkplace
Nominal Learning
Activities Contents
Duration Methods
Introduction
Sessions
Evaluation
Summary
Resources

4. Session Plan ____
Unit of Competence : perform minor maintenance
Module Title : minor maintenance
LO 02_ : carry out minor maintenance
Session Objectives: At the end of this session the learners shall be able to –
Selecting using suitablepersonalprotectiveequipment accordingtoOHS
requirements
Greasing,lubricationandotherbasicservicingof machineryandequipment
accordingto operator’smanual/manufacturers specifications and
supervisor'sinstructions.
Regular adjustmentsandrepairs accordingtooperators'
manual/manufacturers’specificationsandsupervisors instructions
conducting work according to OHSrequirementsand
supervisor’srequirements
Nominal Learning
Activities Contents
Duration Methods
Introduction
Sessions
Evaluation
Summary
Resources

5. Session Plan ____
Unit of Competence : perform minor maintenance
Module Title : minor maintenance
LO 03_ : complete minor maintenance
Session Objectives: At the end of this session the learners shall be able to –
cleaning, returning and storing tools accordingto
manufacturers’specifications and enterpriserequirements
followingEnvironmentalprocedures and collecting, treating and
disposing/recycling waste from maintenanceactivities
Maintenance and clearance of Workarea accordingtoOHS and enterprise
requirement
Reporting Malfunctions,faults, wear or damage oftools tothesupervisor
accordingtoenterprise requirements
Nominal Learning
Activities Contents
Duration Methods
Introduction
Sessions
Evaluation
Summary
Resources