1. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
IEEE MATLAB SIMULATION & CODING
2012
1. A Novel STATCOM control scheme for grid connected wind driven
Induction Generator for Power Quality Improvement
2. Design and Analysis of Interleaved Boost Converter for Renewable Energy
Source
3. High-Power Bidirectional DC–DC Converter for Aerospace Applications
4. A Research on Cascade Five-level Aeronautical Active Power Filter
5. A Voltage-Controlled PFC Cuk Converter-Based PMBLDCM Drive for Air-
Conditioners
6. The study of H-bridge Cascaded Single-Phase Active Power Filter Based on
Instantaneous Reactive Power Theory
7. A Switched-Capacitor DC–DC Converter With High Voltage Gain and
Reduced Component Rating and Count
8. A New Multilevel Converter Topology With Reduced Number of Power
Electronic Components
9. A Novel Single Z-Source Based Multi Level Inverter for Renewable Source
10. Single-Stage Boost Inverter With Coupled Inductor
11. Novel High Step-Up DC–DC Converter With Coupled-Inductor and
Switched-Capacitor Techniques
12. Three-Phase to Seven-Phase Power Converting Transformer
13. A Low Cost Fly back CCM Inverter for AC Module Application
14. Three-Phase Hybrid Multilevel Inverter Based on Half-Bridge Modules
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
2. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
15. A Control Strategy of Hybrid Active Filter to Compensate Unbalanced
Load in Three-Phase Three-Wire Power System
16. Multilevel Current Waveform Generation Using Inductor Cells and H-
Bridge Current-Source Inverter
17. Modified Staircase Modulation for Extending Unbalanced Loads Range of
Cascaded H-bridge
18. Consideration of CSI drive for SRM compared with VSI drive
19. A New Multilevel Converter Topology With Reduced Number of Power
Electronic Components
20. Design Considerations for DSP-Controlled 400 Hz Shunt Active Power
Filter in an Aircraft Power System
21. Design and Implementation of a New Multilevel Inverter Topology
22. Simulation and study on cascaded nineteen-level dynamic voltage restorer
23. Three-Phase Inverter Fed BLDC Motor Drive
24. An Improved Pulse Width Modulation Method for Chopper-Cell-Based
Modular Multilevel Converters
25. Analysis of a Bidirectional DC-DC Converter with Wide Voltage
Conversion Range
26. A Novel Single-Phase Five-Level Inverter With Coupled Inductors
27. A Unity Power Factor Control Method of PWM Rectifier
28. Design and Development of DC-DC Buck Converter for Photovoltaic
Application
29. High-Step-Up and High-Efficiency Fuel-Cell Power-Generation System
With Active-Clamp
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
3. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
30. Three-phase Three-level One-Cycle Controlled Bidirectional AC-to-DC
NPC Converter.
31. A New Control Method of Wind Energy in Power System.
32. Grid-Connected Three-Input PV/FC/Battery Power System with Active
Power Filter Capability.
33. Improvement of Power-Conversion Efficiency of a DC–DC Boost Converter Using a
Passive Snubber Circuit.
34. Analysis and Design of the Integrated Double Buck–Boost Converter as a High-Power-
Factor Driver for Power-LED Lamps.
35. Rotating-Sliding-Line-Based Sliding-Mode Control for Single-Phase UPS Inverters.
36. Analysis and Implementation of a Novel Bidirectional DC–DC Converter.
37. Flatness-Based Control of Three-Phase Inverter with Output LC Filter.
38. DC Link Active Power Filter for Three-Phase Diode Rectifier.
39. Analysis and Design of the L m C Resonant Converter for Low Output Current Ripple.
40. Design and Implementation of a ZCS-PWM Half-Bridge Boost Rectifier With Output
Voltage Balance Control.
41. New Efficient Bridgeless Cuk Rectifiers for PFC Applications.
42. PI and Sliding Mode Control of a Cuk Converter.
43. A ZVS Grid-Connected Three-Phase Inverter.
44. Battery Energy Storage for Enabling Integration of Distributed Solar Power Generation.
45. A Novel Integrated Magnetic Structure Based DC/DC Converter for Hybrid Battery/Ultra
capacitor Energy Storage Systems.
46. Analysis of Novel DC-DC Boost Converter topology using Transfer Function Approach.
47. PWM Based Sliding – mode Voltage Controllers for DC – DC Converter Applications.
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
4. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
2011
1. Control and Performance of a Cascaded Shunt Active Power Filter for
Aircraft Electric Power System
2. Three-Phase Dual-Buck Inverter With Unified Pulse width Modulation
3. A Five-level Inverter topology for Four Pole Induction Motor Drive with
single DC Link
4. A Switched-Capacitor Inverter Using Series/Parallel Conversion With
Inductive Load
5. Semi-Bridgeless Boost PFC Rectifier for Wide Voltage Input Range Based
on Voltage Feed-Forward Control
6. A Novel DC Voltage Control Method for STATCOM Based on Hybrid
Multilevel H-bridge Converter
7. Switching Pattern Selection scheme Based Cascaded Multilevel Inverter Fed
Induction Motor Drive
8. A New Schematic for Hybrid Active Power Filter controller
9. An Advanced Modulation Technique for the Cascaded Multilevel Inverter
Used As A Shunt Active Power Filter
10. A Novel High Step-Up DC–DC Converter for a Micro grid System
converter
11. A Three-Phase Unity Power Factor Single-Stage AC–DC Converter Based
on an Interleaved Fly back Topology
12. Three-Phase Soft-Switching Inverter With Minimum components
13. A New Nine-Level Active NPC (ANPC) Converter for Grid Connection of
Large Wind Turbines for Distributed generation
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
5. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
14. Non isolated Bidirectional Zero-Voltage-Switching DC–DC Converter
based Simulation of Custom Power Electronic Device D-STATCOM –A
Case Study
15. Design And Application Of A Novel Current Mode Controller On A
Multilevel STATCOM
16. Analysis and Design of a Cost Effective Converter for Switched Reluctance
Motor Drives Using Component Sharing
17. Voltage Sag Compensation of Point of Common Coupling (PCC) Using
Fault Current Limiter
18. Load Compensation for diesel generator based isolated generation a system
employing DSTATCOM
19. A Novel Power Converter of High Voltage Switched Reluctance Drive
20. Modeling, Analysis and Control of Various Types of Transformer less Grid
Connected PV Inverters
21. Cascaded multilevel inverter based active filter for power line conditioners
using Instantaneous Real Power Theory
22. Power Quality based Performance Analysis of a Dual Buck Converter Fed
Four-Quadrant DC Drive
23. Three-Phase Three-Level PWM DC–DC Converter
24. A Novel Three-Phase to Five-Phase Transformation.
25. A FACTS Device Distributed Power-Flow Controller (DPFC)
26. A Dynamic Voltage Restorer Equipped With a High-Frequency Isolated DC–
DC Converter.
27. A Novel Power Quality Compensator for Negativesequence and Harmonic
Currents in High-speed Electric Railway.
28. Nine level Cascaded H-bridge Multilevel DC-Link Inverter.
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
6. #2/494, 2ND Floor,
AL Ghouse Plaza, Nagarajupet,
SMART PRO Kadapa
TECHNOLOGIE
S
CODING BASED PROJECTS
1. Optimal Allocation of Distributed Generation in Distribution System for Loss Reduction.
2. Poisson Noise Removal From Images Using the Fast Discrete Curvelet Transform.
3. A Novel Approach for Image Retrieval Based on ROI and Multifeatures Using Genetic
Algorithm.
4. Simulation of transmission line configuration to determine corona losses.
5. Optimal Size and Location of Distributed Generations for Minimizing Power Losses in a
Primary Distribution Network.
6. Distributed Generator Placement and Sizing in Unbalanced Radial Distribution System.
Ph: 08562 222 333, 98856 52333
Email: mail2smartpro@gmail.com
