spring end grinder

1. Page 1
www.engineeringminiprojects.com
MECHANICAL ENGINEERING
wwwwww..eelleeccttrroonniiccsseennggiinneeeerriiggpprroojjeeccttss..ccoomm
www.engineeringminiprojects.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
Email-.engineeringprojectsonline@gmail.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
SEMINAR TOPICS-PROJECTS-PAPER PRESENTATIONS
AUTOMATIC END GRINDING
Department of Mechanical engineering
Department of Electrical and Electronics

2. Page 2
www.engineeringminiprojects.com
MECHANICAL ENGINEERING
wwwwww..eelleeccttrroonniiccsseennggiinneeeerriiggpprroojjeeccttss..ccoomm
www.engineeringminiprojects.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
Email-.engineeringprojectsonline@gmail.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
SEMINAR TOPICS-PROJECTS-PAPER PRESENTATIONS
Abstract:
An automatic end grinding is the machine used for the application of metal removing
process which is mainly design for the springs (heavy duty of about 300mm dia, suspensions
unit).I have chosen this machine for the purpose of grinding the spring surfaces and this type of
machine is in use to grind the single face of the spring of the range of 60mm-150mm coil
diameter. Here, I have modified the machine for easy operation of high range of diameter of
about 300mm and to operate double face grinding. The arrangement of the machine is that the
grinding wheels are placed in an axis the machine. The grinding wheels setup is made to
connect the motor arrangement using bearings and rack and pinion setup. The work hold
device is made to coincide to the axis of the wheels. The device is regulated by the application
of gear box and motor. The wear of the abrasive material is sucked using the vacuum pressure
which is placed perpendicular to the work holding device. The overall setup is covered by the
casing of cast iron. The overall efficiency is same compared to the single face grinding but the
work time reduces to half the wheel differences can be adjusted as per user needs. The power
transmission can be controlled using bearings. I concluded that the above mentioned
advantages result in better advancement in the production of springs.

3. Page 3
www.engineeringminiprojects.com
MECHANICAL ENGINEERING
wwwwww..eelleeccttrroonniiccsseennggiinneeeerriiggpprroojjeeccttss..ccoomm
www.engineeringminiprojects.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
Email-.engineeringprojectsonline@gmail.com
wwwwww..sseemmiinnaarrttooppiiccssffoorrccoommppuutteerrsscciieennccee..ccoomm
SEMINAR TOPICS-PROJECTS-PAPER PRESENTATIONS