1. 1A
DTC Table
ECM
DTC DTC name DTC detecting condition DTC
detection
logic
MIL
P0031
HO2S Heater Control
Circuit Low
Voltage of HO2S heater circuit
is lower than specification for
more than 5 sec. even though
control duty of HO2S heater is
lower than 75% with engine
running.
3 D/C Applicable
P0032
HO2S Heater Control
Circuit High
Voltage of HO2S heater circuit
is higher than specification for
more than 5 sec. even though
control duty of HO2S heater is
higher than 25% with engine
running.
3 D/C Applicable
P0107
Manifold Absolute
Pressure/Barometric
Pressure Circuit Low
Voltage of MAP sensor signal
circuit is lower than 0.15 V for
5 sec.
3 D/C Applicable
P0108
Manifold Absolute
Pressure/Barometric
Pressure Circuit High
Voltage of MAP sensor signal
circuit is higher than 4.88 V for
5 sec.
3 D/C Applicable
P0112
Intake Air Temperature
Sensor1 Circuit Low
Voltage of IAT sensor signal
circuit is lower than 0.15 V for
5 sec.
3 D/C Applicable
P0113
Intake Air Temperature
Sensor1 Circuit High
Voltage of IAT sensor signal
circuit is higher than 4.85 V for
5 sec.
3 D/C Applicable
P0117
Engine Coolant
Temperature Sensor1
Circuit Low
Voltage of ECT sensor signal
circuit is lower than 0.15 V for
5 sec.
3 D/C Applicable
P0118
Engine Coolant
Temperature Sensor1
Circuit High
Voltage of ECT sensor signal
circuit is higher than 4.85 V for
5 sec.
3 D/C Applicable
P0122
Throttle/Pedal Position
Sensor/Switch “A” Circuit
Low
Voltage of TP sensor signal
circuit is lower than 0.1 V for 5
sec.
3 D/C Applicable
P0123
Throttle/Pedal Position
Sensor/Switch “A” Circuit
High
Voltage of TP sensor signal
circuit is higher than 4.7 V for
5 sec.
3 D/C Applicable
P0130
O2 Sensor Circuit
This DTC is detected if any one
of the following conditions is
met.
•Circuit voltage of HO2S is
lower than 0.3 V for more than
specified time with engine
running.
•Circuit voltage of HO2S is
higher than 0.6 V for more
than specified time with engine
running.
3 D/C Applicable
P0327 Knock Sensor1 Circuit Voltage of knock sensor signal 3 D/C Applicable

2. Low circuit is lower than 1.23 V for
5 sec.
P0328
Knock Sensor1 Circuit
High
Voltage of knock sensor signal
circuit is higher than 3.91 V for
5 sec.
3 D/C Applicable
P0335
Crankshaft Position
Sensor “A” Circuit
CKP sensor signal is not input
for more than 3 sec. even if
CMP sensor signal is input.
1 D/C Applicable
P0336
Crankshaft Position
Sensor “A” Circuit
Range/Performance
Output signal pulse of CKP
sensor is out of specified
pattern more than specified
times.
1 D/C Applicable
P0340
Camshaft Position Sensor
“A” Circuit
CMP sensor signal is not input
for more than 3 sec. even if
CKP sensor signal is input.
1 D/C Applicable
P0341
Camshaft Position Sensor
“A” Circuit
Range/Performance
Output signal pulse of CMP
sensor is out of specified
pattern more than specified
times.
1 D/C Applicable
P0443
Evaporative Emission
System Purge Control
Valve Circuit
Measured signal duty of EVAP
canister purge valve control
circuit is different from control
command duty for 5 sec.
(Circuit open or short)
3 D/C Applicable
P0480
Fan 1 Control Circuit
Measured voltage of radiator
cooling fan relay output is
different from its command
signal for 5 sec.
3 D/C
Not
applicable
P0500
Vehicle Speed Sensor “A”
Vehicle speed signal is not
input, while fuel is cut at
deceleration for 4 sec.
continuously with engine speed
at 3,600 rpm or less.
3 D/C Applicable
P0505
Idle Air Control System
ISC control duty pulse is not
detected as its measured
signal.
3 D/C Applicable
P0601
Internal Control Module
Memory Check Sum Error
Data writing error or check
sum error.
1 D/C Applicable
P0602
Control Module
Programming Error
Data programming error. 1 D/C
Not
applicable
P0616
Starter Relay Circuit Low
No starter switch ON signal is
input even if engine has been
started.
3 D/C Applicable
P0617
Starter Relay Circuit High
Starter switch ON signal is
input for more than 180 sec.
after engine has been started.
3 D/C Applicable
P1614
Transponder Response
Error
Refer to DTC Table.
1 D/C
Not
applicable
P1621
Immobilizer
Communication Line Error
1 D/C
Not
applicable
P1622
EEPROM Reading /
Writing Error
1 D/C
Not
applicable
P1623 Unregistered Transponder 1 D/C
Not
applicable
P1625 Immobilizer Antenna 1 D/C Not

3. Error applicable
U0073
Control Module
Communication Bus Off
Transmitting and receiving
error of ECM for specified time
continuously.
1 D/C
Not
applicable
U0155
Lost Communication With
Instrument Panel Cluster
(IPC) Control Module
ECM lost communication with
combination meter.
1 D/C
Not
applicable