simple energy report

1. Energy Measuring Company By Team Bunsen Burner

2. Meet the team Team Bunsen Burner A## J##: Head of Department T##### L##: Leading Executive S#### S#####: Senior analyst A##### N#: Junior Executive

3. Objective brief It is our mission to observe and test gas efficiency inside Bunsen Burners. We must find out what type of flame is the most efficient and energy saving. We have 3 periods to analyse and publish our findings, which could provide you and your families information about gas and energy. By using our research, you could save money per year and help us prevent energy wastage around the globe.

4. Experiment Aims We aim to prove the difference between a high heat bunsen burner and a low heat, and compare the energy usage and the temperature increase speed. By using our information, this data could then be used for gas stoves, barbeques and petrol for cars. As an elite small group, we will provide lab-tested results quickly and efficiently for free, giving the world vital info regarding energy usage.

5. Hypothesis We expect the high heat gas flame to heat, fill and evaporate faster than the low flame because, as you may have noticed, the lower flame would heat slower, fill spaces slower and take more time to get liquids and gases to the aimed temperature- costing more gas and therefore more expense.

7. Beaker filled to 100mL

8. Starting temperature is 24.5°C

9. Finishing temperature is 60°C

10. Time taken to 60°C was 3:20 E F G ° ° A: Bunsen Burner B: Tripod C: Gauze mat D: Beaker E: Thermometer F: Clamp G: Boss head H: Retort stand D ° ° C B H A

12. Beaker filled to 100mL

13. Starting temperature is 24.5°C

14. Finishing temperature is 60°C

15. Time taken to 60°C was 11:06 E F G ° ° A: Bunsen Burner B: Tripod C: Gauze mat D: Beaker E: Thermometer F: Clamp G: Boss head H: Retort stand D ° ° C B H A

17. Experiment b: 100mL x 35.5°C x 4.2 = 4.2Kjs x 11:06=46.45

18. The 1st part of the experiment was almost 3 x more efficient than the 2nd part.

19. The 1st part (high gas) cost $0.00104 and 59.2 mL of gas

21. To fill the balloon took 4 seconds

22. The balloon has 74 mL capacity

23. Gas per second: 16.25mLB A: Bunsen Burner B: Balloon A

25. To fill the balloon took 5.6 seconds

26. The balloon has 74 mL capacity

27. Gas per second: 12.87mL per secondB A: Bunsen Burner B: Balloon A

29. The low gas measured 80% speed