Tech Startup Growth Hacking 101 - Basics on Growth Marketing
Astec Various Roof Projects
1. SECTION II
Other Roofs
Insulating Coatings Corporation
956 South Highway 41
Inverness, Florida 34450
(800) 345-5306
2. Client:
Southland Hatchery
Enterprise, AL
22,000 sq. ft. Built Up Roof
Posi ti ve slope
ASTEC WPM #8
ASTEC#100
ASTEC WPM #8 waterproof
membrane was applied at a thickness I!I)I;~~~~_~=~-......
of 20 mils. Polyester cloth
reinforcement was placed on all
over-lap seams.
--- _
ASTEC # 100 ceramic finish coat
15 mils dft was applied on top.
Page ll-I
3. Built Up Roof
Client:
Heritage Lincoln-Mercury
Charleston, SC
Dealer:
Industrial Maintenance Solutions,
Inc.
This project had three layers of re-
roofing; a complete tear down to
the original roof substrate was
required.
The ASTEC WPM #8 with
polyester cloth reinforcement was
applied over all seams.
Two coats of ASTEC WPM #8
were applied over the entire surface.
Two coats of ASTEC # I00 ceramic
finish coat were applied on top.
Project completed: June 1988
Page 11-2
5. Client:
Anaheim Convention Center
Anaheim, CA
Dealer:
P.D, Inc.
Project:
80,000 sq. f1. Metal Roof
Heavy gauge deep "V"
R-Panel. 25 year old Dome Roof
Due to the curvature of the roof panels.
daylight was visible from the underside
of the roof through the horizontal end
lap seams. Additional self tapping
screws were installed as well a butyl-
backed peel & stick tape with ASTEC
WPM #9 waterproof membrane.
ASTEC # 900 Ceramic Acrylic Coating
was used as the protective finish coat.
This project is supported with a Ten
year Material and Labor Warranty
Project completed: August 1997
Page ll-4
6. Client:
University Cyclery
Bicycle Shop, Austin, TX
Dealer:
Protective Coatings of Texas
Project:
Built Up Roof, slightly pitched, positive water
flow
This project had all gravel spudded off the roof to
provide a smooth surface for the ASTEC Coating System.
One-way roof vents were installed approximately every 500 sq. ft. to allow the pre-existing roof
substrate to breathe. A coating of ASTEC WPM #9 waterproof membrane (20 mils dft) was
embedded with polyester cloth reinforcement over the entire surface.
Finish coated with ASTEC #900 Ceramic Acrylic Coating.
Page ll-5