2. Problem Statement:
– Many people’s body temperature has not been screened in crowded places
during the pandemic situation of Novel Corona Virus level 3 community spread
stage.
3. The Reason Behind Selecting This Topic
– One of the main reason to choose this topic is to help government recognise
the symptomatic people so that the spread of the virus can be controlled.
– As we all know the world is suffering from Novel Corona Virus (Covid-19)
– Government has made the facility of screening the temperatures of the people
who are going on and out of some place like an airport
– It is not possible to screen all the people crossing that facilities due to great
crowds, due to which many symptomatic people enter the infrastructure.
– Which I turn can spread the virus a lot
4. Problem Solution:
– The only thing required is proper temperature screening devices which can be
done via this kind of devices.
– The ultra sonic sensor in the circuit will recognize the people in its surrounding
and the infrared temperature sensor will record the temperature of the people
detected by the ultrasonic sensor and will help to identify the symptomatic
patients with high temperature.
5. Working of the Temperature
Screening Sensors
– The working of the circuit is very simple.
– First the ultrasonic sensor will detect people in a standard range after which the
infrared temperature sensor will then screen the temperatures of the people
detected by the ultrasonic sensor.
– If the temperature goes above the specified measure that is 37 degrees
centigrade then the led in the circuit will glow.
9. Challenges:
– The only challenge which I faced was a technical glitch in tinker cad that can not be
resolved which is the temperature thing.
– The input show while the simulation is 25 centigrade at the beginning but the actual
input that is taken by the software is around 74.41 centigrade. But the coding is
correct you can verify the codes in any other software too they will work. Due to this
reason the led is glowing all the times.
– I hope you have understood the issue which I am having and will look into it if
possible. And also I had started using tinker cad in 2019 so I had explored many
things and also learned many things that’s why I was able to code this thing
