Transformer of low voltage is a distribution transformer in which both the main and secondary windings planned to activate at system voltages in the low power program.

1. Discover the Process to Wire a Transformer of Low Voltage
A low voltage transformer is normally utilized at the user end of the
power network. This type of transformer occasionally named as a
magnetic low voltage transformer. Transformer of low voltage is a
distribution transformer in which both the main and secondary windings
planned to activate at system voltages in the low power program.
It is quite simple to wire a transformer of low voltage and even you can
tie a low voltage transformer within a small amount of time. To wire a
transformer of high transformer voltage and low voltage here are some
basic process given below:
Let’s see the few essential things which are required to wire a low
voltage transformer:
• Cable strippers
• Low voltage transformer
• Screwdriver
• fitted
• Philips
Here the easy procedure is given to wire a transformer:
• The first and foremost thing which you need to do is just watch the
label of nameplate that is there on the low voltage transformer as

2. well as the equivalent elevated area or prime connections. In
general the elevated sides fatal of the transformer are well-known
like the same as 480 VAC inputs and H1, H2 as well as H3, H4
intended for 240. For most of the low voltage transformers the
120VAC input could be just a double screw bond. You have to go
after the nameplate chart in favor of the entire execution prior to
some execution to a transformer.
• Next thing you need to do is to just attach the transformer intended
for a 230 or 480VAC main input. Now interrelate the H2 and H3
terminals by means of the merchant presented high jumper of
metal, otherwise formulate a small cable jumper through banding a
small portion of cable with the cable strippers. Consequently affix
the jumper by making use of the screwdriver and make tighter the
screw fatal to make safe the cable jumper in position.
• This is the third step of wiring a transformer in which you need to
connect elevated voltage wires or the input to H1 and H2.With the
help of X1, X2 and X3, X4 the terminals of low voltage will be
recognized . The interrelation of the surface of low voltage or

3. secondary terminals subordinates on the elevated side otherwise
main voltage.
• Now this is the time to terminate the small face of the transformer
in support of 480VAC main inputs. As you have done the
connection in previous step similar to that you need to connect
terminals X2 and X4. Moreover, one of the outputs of low voltage
ropes can be attached to any one of them, out of these terminals. It
is essential for you to connect X1 and X3 in the similar way as
well as the additional wire of low voltage will attach to this joint
fatal.