polycom , group series, setup, hardware

RealPresence Group Series backplanes and
line drawings
© Polycom, Inc. All rights reserved.
Specifications are subject to change without notice.
1

RealPresence Group microphone array (MACO)
2

RealPresence Group remote control
3

EagleEye Acoustic camera
4
• 6’ cable included
‒ No way to extend it so the use case of
huddle/SOHO office is limited to that
distance from the codec.
• FAQ attached

RealPresence Group 300/500 backplane
1 COM
CLink 2 audio input
2 devices maximum
2 USB 2.1
2 COM
5
+12V
HDCI
1
HDMI 1.3
2
HDMI 1.3
HDMI 1.3
VGA
1
Mini-DIN
8 pin
+12V
HDCI
1
HDMI 1.3
2
HDMI 1.3
Mini-DIN
8 pin
HDCI camera input
Supports audio from
EagleEye Acoustic
YPbPr & TDMS digital
HDMI video and audio
TDMS digital / VGA
video #2 input
3.5mm
audio input
Line level
Monitor #1
output
HDMI w/ audio
or DVI
Main audio
output
3.5mm
Monitor #2
output
HDMI or DVI
1G LAN
Serial
interface
8-pin DIN
Power
Supply
input
RealPresence Group 300
RealPresence Group 500
IR receiver in front of case and on HDCI input

RealPresence Group 300 Dimensions
6

RealPresence Group 500 Dimensions
7

RealPresence Group 300/500 Power supply
8

RealPresence Group 700 backplane
HDCI input
VGA input
Supports audio from EagleEye Acoustic
YPbPr & TDMS digital
Input #2 also supports VGA
Audio input
Stereo RCA
line level
9
HDMI input
With audio
3.5mm audio input
Line level
Associated with input #3
Monitor outputs #1-3
3 is content only
HDMI with Audio
YPbPr or RGB
Power
interface
2 x CLink 2
Total of 3
devices
Serial
interface
(DB9f)
Not active
Grounding
connection
2 *
USB 3.0
1Gig LAN
Host & Slave
Video input
Composite or
Component
Audio output
Stereo RCA
line level
Audio input
Stereo RCA
line level
Associated with
input 4
At 1st release USB
will not be active
IR receiver in front of case and
on HDCI inputs #1 & 2

RealPresence Group 700 power states
10
• Notes:
1. Retained Power State is ‘ON’ if the
A/C power was previously removed
when the codec was NOT in the “OFF
State”. Otherwise, Retained Power
State is ‘OFF’.
2. Codec Option allows the IR Remote’s
Hang‐Up Button to be set for ‘Off’, or
‘Sleep’ functions
3. Codec Option allows the Monitors to
drive ‘Black’ or ‘No Signal’ when in the
‘Sleep State’
4. Codec Option to set elapsed time
before entering ‘Sleep State’
5. Camera’s IR detector is only active
when the camera is powered either by
codec, or w/ external adapter

RealPresence Group 700 line drawing
11

EagleEye IV standard configuration
12

EagleEye IV wide angle lens configuration
13

EagleEye IV camera Options
• RealPresence Group Series bundles shipping
‒ Korea and Russia now due 7/1/2014, dependent on regulatory approvals.
• Standalone EagleEye IV camera
‒ 12x (8200-64350-001)
‒ 4x (8200-64370-001)
• Cables, shipping schedule follows bundles:
‒ HDCI on the codec side, mini-HDCI on the camera side, see photo
‒ 3m cable, standard ships with all EagleEye IV cameras – (2457-64356-001)
‒ 1m cable – (2457-64356-100)
• EagleEye Digital Extender – (2215-64200-001)
• Wide angle lens – (for 4x 2200-64390-002, for 12x 2200-64390-001)
‒ This lens causes artifacts at the edges when zoomed all the way out. Thus priced low
• ‘Eye Patch’ for secure installations – (2215-28454-002)
• Mounting shelf – (2215-24143-001, current shelf)
‒ Update will be forth coming to allow the EagleEye IV to be mounted in all configurations, and
include consideration for mounting the EagleEye Digital Extender
© Polycom, Inc. All rights reserved. 14

Polycom EagleEye Digital Extender
• Polycom branded adaptor will allow EagleEye IV (4x & 12x) to connect
via HDCI
• Adaptor boosts signal allowing camera to be extended over CAT 6a to
lengths up to 100m / 330 ft (1080p), cat 5e for shorter runs to be
accepted
− Loops limited, see installation guides
− Solid conductor cable, not stranded/patch cord
• Flexibility for integrators
• Ease of ordering for customers
− Power cord ordered separately or
provided by customer
• Based on HDBaseT technology
− Additional information on HD BaseT
Cat 6a up
to 100m
Not to scale

Cable detail for EagleEye Digital Extender
• Polycom strongly recommend customer to use high quality Shielded, solid conductor CAT6A variety (F/UTP) cable or a
qualified HDBaseT cable(http://www.hdbaset.org/cables) for optimal performance.
• Use the shortest patch cable that is reasonable – don’t use a 5 meter when you only need a 1 or 2 meter. This minimizes
the amount of extra wire to dress properly
• On excess cable – do not coil it up or bowtie it. Let it drape and/or run straight and make gentle bends when appropriate
• Minimize coupling to other cables (even itself). Want to avoid laying it next to AC cords, other Ethernet Cords, HDMI, etc.
(This is where shielded CAT6A could be used without this being an issue).
• Avoid using zip ties to bundle or secure the cable in anyway – especially CAT 6A. Use Velcro ties when necessary.
• Indicate that solid wire is preferred for any distance beyond 10 meters (that is total distance) Stranded wire (except for short
patch cables) must be avoided. Even for patch cables, solid wire would be better.

EagleEye Digital Extender line drawing

RealPresence Group 300/500 mounting
hardware
2215-65169-001: Mounting bracket for RealPresence
Group 300 & 500. Allows EagleEye camera and
codec to be mounted together. Recommends use of
2215-24143-001 mounting bracket for wall/display
mounting.
18

1u mounting shelf for the RealPresence Group
300/500 codecs
• 2215-06177-001
• LDSC: Shelf for mounting the RealPresence Group 300 & 500
series codecs. This is a black 1u shelf for 19" racks which will
hold the codec in position with a secure mounting system. 1u
(1.75 inches) x 17.5” (without ears, 19” with) x 9.8” deep. Shelf
only.
19

RealPresence Group Series mounting solutions
• U or Sandwich mounting
‒ 2215-65169-001, current price list
• 1u shelf
‒ 2215-06177-001, September price list
• Retrofit “L” bracket for CP options
‒ Only as part of a CP solution, for converting existing HDX
Media Center and HDX Executive Collection to use a
RealPresence Group Series codec
• 3RD party behind the monitor mount
‒ KCG POLYCOM GROUP SERIES MOUNT
‒ contact@keyserconsultingroup.com, 717.549.3600
• Updated StereoSurround kit
‒ Universal subwoofer update for WW energy requirements, one
sub with 2 different fuses (120v or 240v)
‒ 2200-65878-001, August price list

42” RealPresence Group Series Media Centers
Available only as dual screen

Available as single & dual screen

Dual does not
support mobility –
casters.

Available as
single and dual
screen
These dimensions
only for single
screen. Dual
screen uses 2 of
these side-by-side,
2nd does not
have a camera.
Camera can be
mounted above
either of them, but
with the codec.

Lower Camera Mount (LCM) viewing heights
With
casters
With
slides

See this web link for DXF and PDF of all the Group Video
products:
http://planetpolycom/sites/sales/VSG/VSG%20Dimensional%
20Drawings/Forms/AllItems.aspx
27

polycom , group series, setup, hardware

Recomendados

Recomendados

Mais conteúdo relacionado

Mais procurados

Mais procurados (20)

Destaque

Destaque (20)

Semelhante a polycom , group series, setup, hardware

Semelhante a polycom , group series, setup, hardware (20)

Último

Último (20)

polycom , group series, setup, hardware

Notas do Editor