1. Planning of use of soundtrack
and sound effects
Callum Carmichael

2. This is the first website I chose to use a non-copyrighted horror soundtrack. The extent of free and non-copyrighted horror soundtracks and sounds
available were very wide and allowed me to look through a variety of sounds until I found one that would fit my trailer.

3. This is the first website I chose to use a non-copyrighted horror soundtrack. The extent of free and non-copyrighted horror soundtracks and
sounds available were very wide and allowed me to look through a variety of sounds until I found one that would fit my trailer.

4. This was one of the original non-copyrighted soundtracks that I chose to have within my trailer. I opened up the software programme Audacity so I could
make necessary changes to the soundtrack.

5. I then imported my final soundtrack file into Audacity so I could work with both tracks and create the exact sound I wanted within my trailer.

6. I moved my top layer soundtrack down the timeline towards the 30 second mark in which I wanted it too begin. As the soundtrack below it would allow the
build up towards my main soundtrack on the top level.

7. I then split my lower soundtrack into two sections. As I wanted to change the tempo of the lower split layer.

8. I went into the effects panel and chose change speed.

9. The change speed panel allowed me to increase the speed of the track and thus create a faster tempo within the track leading up to the crescendo.

11. I then once again split the last 30 seconds of the track again

13. I then increased the tempo of this track even further to create the ultimate peak of the song and the crescendo which would then ensue.

15. I then reduced the top tracks length so it would finish when the trailer finished and thus create a nice fade out after the crescendo.

16. This was my final soundtrack edited. I then saved and exported the soundtrack, finally importing it into Adobe Premier Pro and adding it into my film trailer.