5. Main image inserted
Opened the image in Photoshop
Went onto the magic eraser
tool.
Most of the background was
gone, so I just needed to
remove the smaller areas.
6. Clicked on this to get rid of her badge. I did
this by selecting the colour that I wanted
after clicking on this tool. So firstly, I
wanted to get rid of the badge that was
showing on her top, so I clicked on her top.
I then clicked on the brush tool and
changed the brush type to ‘soft round 13
pixels’
7. I coloured over her top and did the same for the
part of badge that was on her neck and skirt.
Once that was all done and the badge was no
longer visible, I needed to get rid of the excess
bit of background that was left after using the
magic eraser tool.
8. I then cropped the image out so that there was
less background:
After cropping the image, I went onto the blur tool and
blurred the image around. This was to make the edges
smoother:
Without blur: With blur: better/more smooth
9. The image was fully edited. So I changed the contrast to make
her face a little brighter. I did this by clicking onto ‘enhance’ tab
and then brightness.
Then I added the insert. For this I had to edit
the image, so I used the magic eraser tool
and normal eraser to do this on Photoshop.
I then dragged it onto the
publisher document
10. Added the rest…
I added the coverlines, the flash and the barcode:
coverlines
Barcode
Flash
InsertDate
