This document provides instructions for proper uniform wear and care for cadets, including: 1) How to season a beret by pressing the hard flap underneath and folding the sides, which can be secured by placing under a heavy object or ironing. 2) How to iron a beret by pressing in specific areas and folding it back into shape. 3) How to fasten a belt to the female cadet uniform by aligning the belt hook, inserting a safety pin inside the uniform near the belt line, and fastening the pin through the belt. 4) How to iron hemlines on the female cadet uniform by pinching the outer side, folding it into a straight line

2. How to season your beret? (For All Cadets)

3. Identify the hard flap in the beret which is also the support for the Cap Badge

4. Press the beret together with the hard flap underneath.

5. Adjust by folding it further away from you. And press down the surface of the beret which is closer to you.

6. Fold up the side of beret which is closer to you towards the other side

7. Once folded, it will look like this. You can season by putting under a heavy mattress / ironing it.

8. Ironing your beret Ensure that the dial on the iron is either set to wool / 4. If you are ironing your beret for the first time, please be aware that there will be a slight burning smell, and discoloration.

9. Firstly, press the iron on the arrow shown above.

10. Open up one of the sides and iron it down flat.

11. Repeat the same action for the other side of the beret

12. Fold back the beret into the formation for seasoning and press the iron on its surface.

13. Finally, finish off the ironing by repeating step one, which is to iron on the line as shown in the picture.

14. Fastening belt to uniform (For Female Cadets)

15. This is the front view of the female cadet uniform. You are encouraged to iron your uniform first. Focus on the side where the arrow is pointing.

16. Open up your uniform and focus on your right

17. The end of the hook should be placed aligned to the line on the right side of the uniform.

18. Pierce a safety pin near to the line that the belt will be aligned to from inside

19. The safety pin will protrude out this way. This is the view if uniform is buttoned.

20. The belt is made up of 2 layers of cloth. Pierce the belt to the protruding safety pin. Estimate the amount of cloth you want to pin, but not too much. Do make sure that it only pierce through the first layer of cloth, not both layers so as to not making the safety pin visible.

21. Fasten the safety pin on the inner side of the uniform

22. This is how it looks once safety pin has been fasten

23. How to iron the hemlines? (For Female Cadets)

24. This is the top view of the uniform.

26. Up close picture of hem lines.

27. Choose one side to start first. Pinch on the outer side of the hem line.

28. Zoom out view of where to pinch