1. FINAL YEAR PROJECT PPT
ON
DESIGN, INSTALLATION AND FABRICATION OF
RECIPROCATING PUMP
UNDER THE GUIDANCE OF
DR. MANOJ KUMAR BARAI
ASSOCIATE PROFESSOR
DEPARTMENT OF MECHANICAL ENGINEERING
FUTURE INSTITUTE OF ENGINEERING &
MANAGEMENT,
KOLKATA-700150, INDIA
2. Acknowledgement
We are highly grateful to the authorities of FUTURE INSTITUTE OF
ENGINEERING & MANAGEMENT, KOLKATA for providing this
opportunity
to carry out the project work.
We would like to express a deep sense of gratitude & thank profusely to
our thesis
guide Dr. Manoj kumar Barai for his sincere & invaluable guidance,
suggestions &
attitude which inspired us to submit project report in the present form..
We are also thankful to other faculty members of Mechanical
department, FIEM,
Kolkata for their intellectual support. Our special thanks are due to our
3. Team Members
• SOURAV JANA
• JAMES BABY
• KRISHNENDU PRAMANIK
• MD SHABBIR
• SUPRIYA GHOSAL
• PRAMOD SINGH
• SANDEEP KUMAR
• SANJU KUMAR SANJAY
4. Precap
Piston or plunger
Crank and Connecting rod
Suction pipe
Delivery pipe
Suction and Delivery valve
7. Characteristics
• Gives very high pressure but low discharge.
• Can transfer very high viscous or low viscous fluid.
• Can give a constant but also intermittent flow
• It’s a positive displacement pump.
8. List and Dimensions of Parts
SLIP CAPS = 2.8 cm
SLIP TEE =2.8cm
PVC PIPES =2.2cm(HANDLE), 1.8cm(PISTON ROD),
2.8cm(CYLINDER)
PISTON VALVE= MADE OF RUBBER
SLIP COUPLING =5cm
PVC BUSHING =3cm
PVC PLUG
CLOSE RISER
PVC FIPT TEE =2.8cm
TWO DIRECTION CONTROL VALVE
13. Calculation
• Stroke length = 44 cm =L
• Inside Diameter of cylinder=3 cm = d
• Volume=discharge= ?
Volume= (3.14*d^2 /4) * L
after putting the value discharge is 311 cc.