This document provides setup and operation instructions for an ultrasonic scalpel with model number ABC-123-45-678 and serial number 1234-56-879. It details how to connect the generator and hand piece, perform tests, and troubleshoot issues like no power or a non-functioning hand piece. Users are instructed to place the generator on a stable surface, securely attach the power cord and hand piece cable, select a power level, and test the scalpel before use. Common troubleshooting steps include checking cable connections, restarting the generator, and adjusting the power level or volume. A request for repair form is also included to report issues.
8. Turn the torque wrench clockwise until you hear 2 clicks
Indicating that the hand piece is secure.
9. Turn on the generator by pressing the power button located
Located in the right lower corner.
10. Pass off the other end of the cable to be plug in this port
located in the left lower corner.
11. The circulator will then insert and connect the hand piece
into the generator.
12. Your circulator can now start test process by pressing test
button in the generator.
13. You can also perform a test by pressing any of the
button in the hand piece.
14. You will hear 3 beeps when the test is done,
now the ultrasonic scalpel Is ready to use.
15. Throubleshooting
• No Power
-Check if power cord is securely attach and the power button is turned on
• Hand piece not working.
- Check cable connecting to the generator
- Make sure hand piece is tightly connected to the cable
- Restart generator by turning it off and on again
- Perform a retest
• Power is not enough or to much.
- Increase or decrease power by pressing the power level button up
and down as needed.
• Generator is to loud or to low
- Turn volume knob down or up located in the left lower corner next to
the power button.
Report Issue
16. Request for Repair
Ultrasonic Scalpel Generator
Model No: ABC-123-45-678
Serial No. 1234-56-879
Reported Issue: (Choose only one)
No Power
Electrical (e.i. Frayed cable)
Mechanical (e.i. Broken parts)
Other
Choose Room no. 1
2
3
4
5 Send to Bio-med