O slideshow foi denunciado.
Utilizamos seu perfil e dados de atividades no LinkedIn para personalizar e exibir anúncios mais relevantes. Altere suas preferências de anúncios quando desejar.
AIR INJECTION REMOVAL KIT FITTING INSTRUCTIONS(CARB MODELS)1. Remove seat bolts and remove the seat.2. Remove the negative...
Próximos SlideShares
Carregando em…5
×

Thunderbike Air Injection Removal Kit Fitting Instructions - 790 & 865cc Carb Model Triumph Twins

600 visualizações

Publicada em

Instructions for fitment of Thunderbikes SAI elimination kit to carb model Triumph twins - Boneville, Thruxton, Speedmaster, America and Scrambler

Publicada em: Indústria automotiva
  • Login to see the comments

  • Seja a primeira pessoa a gostar disto

Thunderbike Air Injection Removal Kit Fitting Instructions - 790 & 865cc Carb Model Triumph Twins

  1. 1. AIR INJECTION REMOVAL KIT FITTING INSTRUCTIONS(CARB MODELS)1. Remove seat bolts and remove the seat.2. Remove the negative wire from the batterys negative terminal.3. Turn fuel tap off, remove fuel line from tap.4. Lift rear of tank to access fuel tank breather pipe located on the opposite side andforward of fuel tap. Remove pipe and fuel tank.5. Slide back the band clamps and remove the rubber hoses connecting theair injectors to the air injection valve, slide back the band clamps then remove thebreather tube connecting the air box to the air valve. Install the hole plug(supplied) into the air breather box.6. Remove the rubber hose connecting the air valve to the carburetors.Replace with rubber cap (supplied) on the carburetor.7. Remove air valve from frame by removing the 2 bolts.8. Remove the air injectors with a 13mmdeep well socket or wrench. Note:it’s a tight fit with minimal clearance so you may need to modify a tool to suitIf the injector is difficult to remove BE PATIENT. Try soaking thebase of the injector with penetrating oil.9. Install the stainless steel AI Bolts using the suppliedcopper washers. Torque to 15- 20 ft/lbs or "snug" if no torque wrench isavailable. DO NOT OVERTIGHTEN. Note: Place a couple drops ofanti-seize on the threads as this will aid in the removal later if necessary.10. Install remaining removed parts in reverse order.STOP NOW YOU HAVE FINISHED!! Thunderbike Engineering Ltd 2/46A Muritai Street, Tahunanui, Nelson 7011, New Zealand Tel: +64 (0)3 548 5787 parts@thunderbike.co.nz www.thunderbike.co.nz

×