Mechanical ventilation involves using a machine to breathe for patients who cannot breathe effectively on their own. It works by delivering pressurized air into the lungs via a tube in the airway. Physiotherapists help optimize ventilation, clear secretions, prevent complications, and facilitate weaning patients off the ventilator using techniques like suctioning, drainage positions, percussion, and vibrations. The ventilator settings control aspects of breathing like tidal volume, oxygen levels, and respiratory rate. Modes include mandatory breaths or assisting patients' own breaths. Weaning gradually reduces support as the patient recovers lung function and the ability to breathe independently.
2. Index
Introduction
Physiology of normal breathing v/s mechanical ventilation
Indication
Goals
Principles of mechanical ventilation
Types of
Modes of ventilators
Settings of ventilators
Adverse effects of
2
3. Introduction
• Ventilation can be defined as the process
of exchange of air between the lungs and
the ambient air
• In the clinical setting, a machine known as
a mechanical ventilator is used to perform
this function on patients faced with serious
respiratory illness.
3
4. Physiology of normal breathing v/s mechanical
ventilation
Normal breathing
• Breathing by muscles is governed by
requirement of body
• Initiation and termination of breathing depend on
levels of pO2, pCO2, pH and lung inflation.
• Air gets sucked in because of negative intra
pleural pressure created by the respiratory
muscles
• Increase in pulmonary pressures are in the
range of 3 to 5cms of water
• Venous return increases during respiration
• Expiration is passive
Mechanical ventilation
• Work of the respiratory muscles is
done by ventilator
• Initiation, termination may be
machine determined(mandatory
breath) or patient determined (
spontaneous breath).
• Air is pushed in by positive
pressure given by the ventilator.
• Pressures generated are in the
range of 15 to 40cms of water.
• Venous return decreases during
respiration
• Expiration is passive 4
6. GOALS
Provide adequate
(not perfect)
oxygenation and
ventilation
1
Reduce our
patient’s work of
breathing
2
Minimize the damage
to the lung caused by
the ventilator known
as ventilator induced
lung injury (VILI).
3
Improve cardiac function
• Decreases preload
• Decreases afterload
• Decreases metabolic
demand
4
6
7. Principles of mechanical ventilation
A ventilator is machine that generates the pressure necessary to cause
a flow of gas that increases the volume of the lungs
The 3 variables involved are-
Pressure
Volume
Flow
One can be fixed or predetermined and the other two will depend on the
compliance of the lungs and the chest wall and the resistance offered by
the airways.
7
8. TYPES OF MECHANICAL VENTILATION
Mechanical ventilation
Invasive ventilation Non-invasive ventilation
8
Ventilatory support that is given
through endo-tracheal intubation or
tracheostomy is called as invasive
mechanical ventilation.
Ventilatory support that is given without
establishing endo-tracheal intubation or
tracheostomy is called non-invasive
mechanical ventilation
10. Settings
• Mechanical Ventilator Settings regulates the
rate, depth and other characteristics of
ventilation.
• Settings are based on the patient’s status i.e.,
ABGs, Body weight, level of consciousness
and muscle strength.
Main settings are-
• Trigger – what initiates a breath
• Target – what the vent is trying to achieve
• Cycle – what causes the breath to end
10
11. 1. Fraction of inspired oxygen {FIO2}
• Concentration of oxygen in
the inspired air
• Use the lowest FIO2 that
achieves the targeted
oxygenation
11
13. 3. Inspiratory: Expiratory(I:E) Ratio
• Ratio of duration of inspiration to expiration
• Normal: longer expiratory phase than inspiratory
phase(1:2,1:3)
• Inverse Ratios provide a longer inspiratory
phase(1:1,2:1,3:1,4:1)
• Reduced I:E allows more time for exhalation and
reduces breath stacking
• Used for patients who have obstructive airway
disease with acute respiratory acidosis
13
15. 5. Peak Flow Rate[PFR]
• Maximum flow delivered by ventilator during inspiration
15
16. 6. Peak inspiratory pressure {PIP}
• Highest proximal airway
pressure reached during
inspiration
• Target PIP is <35 cm H2O
• Low PIP may result in
hypoventilation; High PIP
may cause lung damage
16
17. 7. Plateau pressure(Pplat)
• Reflects pulmonary compliance and is measured by applying
a brief inspiratory pause after ventilation.
17
18. 8. Positive End Expiratory Pressure{PEEP}
• Pressure remaining in the lungs at the end
expiration.
• Used to keep alveoli open and “recruit”
more alveoli to improve oxygenation for
patients.
• High levels may cause barotrauma,
increased intracranial pressure, and
decreased cardiac output.
• 3-10cm H2O
18
19. 9. Pressure support (PS)
• Provides additional
pressure during inspiration
to ensure a larger tidal
volume with minimal
patient effort
• Used to help overcome the
work of breathing through
ventilator tubing
• 8-20cm H2O
19
20. 10. Tidal Volume {VT}
• Volume of gas
exchanged with each
breath
• 6-8mL/kg of ideal body
weight [IBW] to prevent
barotrauma
20
22. Traditionally, physiotherapists have been involved in the respiratory care of patients on mechanical ventilation in
ICU.The respiratory care involves optimisation of ventilation, airway clearance, prevention of pulmonary complications,
and hastening weaning from mechanical ventilation.
Techniques used by physiotherapy to help improve patient breathing and wean patients off ventilators may include:
• Suctioning
• Postural drainage
• Central lavage (Paediatrics)
• Percussion
• Vibrations
22
23. Continuous Mandatory Ventilation (CMV)
• In this mode the ventilator provides a mechanical breath on a preset timing. Patient respiratory efforts are ignored.
• Trigger –Ventilator initiates all breaths
• Patient can not initiate
• Target – Volume
• Cycle – Time
• e.g. Settings - Mode: CMV
• Rate 10; Vt 700cc
• FIO2 0.5; PEEP 5.0
• vent gives cc each
• patient gets zero extra breaths (even if tries)
• very uncomfortable for patient
• only used if patient paralyzed (i.e. in O.R.)
23
24. Assist Control (Volume Control)
• In this mode the ventilator provides a mechanical breath with either a pre-set tidal
volume or peak pressure every time the patient initiates a breath.
• Trigger – machine and patient
• Target – volume
• Settings-Mode: VC
• Rate 10; Vt 700cc
• FIO2 0.5; PEEP 5.0
• e.g. vent gives cc each
• patient initiates 6 bpm – vent provides 700cc
24
25. Synchronized Intermittent Mandatory Ventilation
(SIMV)
• In this mode the ventilator provides a pre-set mechanical breath (pressure or volume limited) every specified number of seconds
(determined by dividing the respiratory rate into 60 - thus a respiratory rate of 12 results in a 5 second cycle time). Within that cycle
time the ventilator waits for the patient to initiate a breath using either a pressure or flow sensor. When the ventilator senses the first
patient breathing attempt within the cycle, it delivers the preset ventilator breath. If the patient fails to initiate a breath, the ventilator
delivers a mechanical breath at the end of the breath cycle. SIMV is frequently employed as a method of decreasing ventilatory
support (weaning) by turning down the rate, which requires the patient to take additional breaths beyond the SIMV triggered breath.
• Trigger – ventilator and patient
• Target – ventilator breaths = set volume
• patient breaths = patient effort
• Settings-Mode: SIMV
• Rate 10; Vt 700cc
• FIO2 0.5; PEEP 5.0
• e.g. vent gives cc each
patient takes cc each
25
26. Pressure Control (PC) Trigger – ventilator and
patient
• Target – Pressure (above PEEP)
• Settings – Mode: PC
• Rate 10; Pressure 24 cm H2O
• FIO2 0.5; PEEP 5
• e.g. vent gives 10 bpm to a peak Paw = 29
• pt takes 6 bpm targeted to peak Paw =29
26
27. Pressure Support Ventilation (PSV)
• When a patient attempts to breath spontaneously through an endotracheal tube, the narrowed diameter of the
airway results in higher resistance to airflow, and thus a higher work of breathing. PSV was developed as a method
to decrease the work of breathing in-between ventilator mandated breaths by providing an elevated pressure
triggered by spontaneous breathing that "supports" ventilation during inspiration
• Trigger – patient only
• Target - pressure
• Cycle – patient flow decrease
• Settings – Mode: PSV = 14 cm H2O
• FIO2 0.4; PEEP 5
• e.g. pt takes 18 Vt = 500cc
• machine gives zero breaths
9/4/20XX Presentation Title 27
28. Completely Unassisted Breaths
• Trigger – patient
• Cycle – patient effort ceases
• Settings: CPAP 5; FIO2 0.4
• e.g. patient takes cc each
9/4/20XX Presentation Title 28
29. Continuous Positive Airway Pressure (CPAP)
• A continuous level of elevated pressure is
provided through the patient circuit to
maintain adequate oxygenation, decrease
the work of breathing, and decrease the
work of the heart (such as in left-sided
heart failure — CHF).
• Note that no cycling of ventilator pressures
occurs, and the patient must initiate all
breaths. In addition, no additional pressure
above the CPAP pressure is provided
during those breaths. CPAP may be used
invasively through an endotracheal tube or
tracheostomy or noninvasively with a face
mask or nasal prongs.
29
30. BiPAP
• Noninvasive positive
pressure ventilation that
delivers a preset
inspiratory positive airway
pressure and expiratory
positive airway pressure
• The tidal volume correlates
with the difference
between the IPAP and
EPAP
30
31. Adverse Effects of Mechanical Ventilation
Pulmonary:
• Intubation effects
• Air leaks
(pneumothorax/BPF)
• Ventilator-associated lung
injury
• Ventilator-associated
pneumonia
• Dynamic hyperinflation/Auto-
PEEP
Cardiovascular:
• Increased CVP
(↑intrathoracic pressure)
• Decreased venous return
• Hypotension
• Increased RV afterload
31
Neuro/muscular:
• ↑ ICP
• Prolonged sedation
• Myopathies
• Neuropathies
Ventilator-Associated
Lung Injury (VALI):
• Volutrauma –
overdistension of alveoli
• Barotrauma – high alveolar
pressures
• Atelectotrauma – repetitive
opening and closing of
alveoli
• Biotrauma – release of
inflammatory mediators into
systemic circulation
32. Procedure of Weaning patient
Weaning is gradual reduction of ventilation. A new systematic review suggests that noninvasive ventilation
after early extubation helps in reducing the total days spent on invasive mechanical ventilation; also, the
patients spending less time on invasive ventilation had lower rates of ventilator-associated-pneumonia. In
some cases, this process is rapid and uneventful; however, for some patients the process may be
prolonged for days or weeks. Weaning is a term that is used in two separate ways. Firstly, it implies the
termination of mechanical ventilation and secondly the removal of any artificial airway.
When to wean
• Normalised I:E ratio
• Reducing FiO2 (usually <0.5)
• No requirement for high PEEP
• Appropriate underlying respiratory rate
• Appropriate tidal volume with moderate airway pressures
32
33. Physiotherapy Role in Mechanical Ventilation
and Weaning
Traditionally, physiotherapists have been involved in the respiratory care of patients on mechanical
ventilation in ICU. The respiratory care involves optimization of ventilation, airway clearance,
prevention of pulmonary complications, and hastening weaning from mechanical ventilation.
Techniques used by physiotherapy to help improve patient breathing and wean patients off
ventilators may include:
• Suctioning
• Postural drainage
• Central lavage (Pediatrics)
• Percussion
• Vibrations
33