1.
How to Setup Linksys wifi extender?
Linksys Wifi range extender manual setup
1. First, keep your laptop or system and the range extender in the same room or space.
2. Next, connect your extender to the computer with an Ethernet cable.
3. You must plug one end of it into the Ethernet port on the extender and the other end into the
Ethernet port on the computer.
4. After that, plug your range extender into a socket and start your system
5. Open your web browser and type extender.linksys.com or Linksys Default IP address
192.168.1.240
6. You will then be redirected to the sign-in page.
7. So enter the information to sign in.
8. After that, on the Linksys Extender Setup screen, enter the SSID of your router in the appropriate
field.
9. The extender should then be powered off manually and left idle for a while.
10. The extender must then be turned on to complete the setup.

2.
Linksys Wifi extender setup using WPS button
By pressing the physical WPS button on your extender and router, you can install the extender.linksys.setup
with the WPS procedure. To proceed with the same, go to these instructions to set up your extender using
the WPS method:
1. Turn on the Linksys range extender first.
2. On the side panel of your Linksys extender, you will find the WPS button.
3. Hold the button for a few seconds.
1. The extender's LED light starts to flash as a result.
1. Put your router through the same procedure now.
1. Once the light flashes, press and hold the same button on router
1. Once the lights on the extender and router have stabilized, observe this after a short while.
This shows that the WPS button-based linksys wifi extender configuration is now complete.

3.
Linksys wifi extender setup in Access Point Mode
linksys wifi extender can be setup in the access point mode. When working in the access point node, the extender expands your
existing wifi network by connecting to your router and access point using campbell.This,in turn, enables your extender to have minimal
performance loss or dropping connection.If you want better wifi speeds,perform the linksys range extender setup process inthe access
point mode
To configure your Linksys extender as an access point, follow these instructions:
1. Turn on your linksys wifi extender by plugging it into a power outlet.
2. The Ethernet cable should be connected to your Linksys extender on one end and your router on the other.
3. Open your preferred internet browser.
4. To configure the extender, go to the Linksys configuration page.
5. When you get there, select As a wired range extender (Access Point).
6. Click Next.
7. Select the Next option.
8. Hit Save after creating an admin WiFi network password for your Linksys range extender.
9. That's all, then! The linksys wifi extender setup in Access Point mode is complete.