2. 1. .STAGE 1: alignment and levelling,
Typodont No 1
Exercise: bend and engage first arch
Wire: .012 , .014
Elastic modules
G7: 3-3:three units chain for double
over-tie 4-6 Thick-powerO 120,
STB: Mini – elastic O loop
Innovation-L – engagement no elastics
2. STAGE 1: alignment and levelling
Creating space for rotations
Wire: SS .016 + coil spring
Creating space before rotations
3. STAGE 1: alignment and levelling
Derotations:
1 . rotation ties, chain overtie –SS .016
2. . full engagement Niti .014-16+
Ligature wires: .08, 010
Floss threader
Full engagement with dental floss
4. German overtie lower arch (G7)
2
3. 5. STAGE 2 Torque control, Typodont
No 2
Place TMA 1.75x1.75 arch wire, steel
ligation
6. Vertical elastics (for Class 2, 3
open bite cases
STB: Place Hooks or Kubayashi
7. STAGE 3 Space closure-Typodont3
Place a SS .016x.022 arch as follows:
“figure 8” anterior and posterior
segments
Steel ligation of 4 and 6
Cuspid inset near cuspids (hold
spaces)
No molar inset (free sliding)
Vertical and transverse bowing
effect compensation
Elastic power is applied in short
span
STB:
1. sliding hooks
2. Kubayashi
3. elastic tie
3
4. 8. STAGE 4 Finishing
Place TMA .016
Inset bend : in and up
9. STAGE 4 Finishing
offset bend : off and down
10. STAGE 4 Finishing
rotation bend :
4
5. After preparation with separator at least 6
hours prior to placement
1. Draw labial long axis, extend to lingual
2. Use Transbond past
for bracket
positioning on the cast
Central Incisor bracket angulation:
3. Lateral Incisor bracket angulation
4. Canine bracket angulation
5
6. 5. Lower incisors : 0 central and lateral, 30
50-canine
.
6. 2D Forestadent brackets
7. Innovation-L
8. Position posterior brackets: relate to
marginal ridges.
6
7. 9. Silicone transfer tray
Instructions for laboratory ext/ non-extr
Bracket positioning technique ( CLASS, TARG, HIRO, full- partial set up
brackets
prescription
bond or skip
over-corrections
wires
templates
7
