1. Curriculum vitae
PERSONAL INFORMATION
Surname Khajavian
Name Mohammad
Address Postal Code 75816 93511.Iran
Telephone +98912 372 7022
Fax -
E-mail mohamadkhajavian@yahoo.com
Viber Mohamad (0098 912 372 7022)
Nationality Iran
Date of birth 11 Jan. 1986
Education and training
M.Sc. Course
• Date Sep. 2012 to Sep. 2014
• Name and type of organisation Islamic Azad University of North Branch Tehran
providing education and training " Faculty of Engineering"
Duration of the program of study 2 Years
• Principal subjects/occupational water and wastewater treatment
skills covered Air pollution
Kinetics and reactor design
Advanced Mass Transfer
Advanced Mathematics
Advanced thermodynamic
• Title of qualification awarded M. Sc. in Environmental Engineering,Chemical Engineering
Final mark obtained 16.17 (Min:0 , Max: 20)
B. Sc. Course
• Date Sep. 2004 to February 2010
• Name and type of organisation Islamic Azad University, Iran
providing education and training "Gachsaran Branch"
Duration of the program of study 6 Years
• Principal subjects/occupational Equipment Selection & Design
skills covered Exchanger Design
Unit Operations & Mass Transfer
Petroleum Refining Bases
Process Control
• Title of qualification awarded B. Sc. in Chemical Engineering
Final mark obtained 13.5 (Min:0 , Max: 20)
2. Graduation thesis (M. Sc.)
Title "Investigation of adsorption of Nickel heavy metal by treated Oman sea’s brown
algae in the presence of interfering metal Cadmium study on kinetic and
equilibrium models"
Language Persian
Supervisor Dr. Nasrollah Majidian (n_majidian@iau‐tnb.ac.ir)
Thesis Summary Adsorption of heavy metals is An effective way to separation and recovery of
heavy metals from aqueous solutions. In this study, the biological Adsorption
of nickel and cadmium ions in a batch system in binary state by brown algae
Cystoseria indica has been investigated.To investigate the biological effects
of adsorption, time and the initial concentration parameters are taken into
consideration, the adsorption isotherms and kinetics model was evaluated for
the two metals simultaneously. According to the results of the initial
concentration of nickel equal to 60 mg/l in the presence of cadmium
concentration 30, 60, 130 mg / l, adsorption of nickel were 20.2 mg / l and
10.6 and 10.1 respectively and the Cd concentrations equal to 60mg/l is and
nickel concentrations 30, 60 and 130 mg/l in solution exists, adsorption of
cadmium were 40.1mg / l and 30.6 and 30.1 of the items within shows the
synergistic effect of cadmium on the adsorption of nickel rather than
synergistic effect of Ni on the absorption of cadmium is the nickel and
cadmium reactions of competitions in which cadmium is crucial, system of
nickel, cadmium, nickel and cadmium that is specified in the competitive
reaction in which Cd is a determinant term. But as nickel ions disturb the
system is involved in high concentrations of nickel, so it cannot be reduced
Cd adsorption. Kinetic results showed for the first model and the second
highest adsorption was performed in the first 60 minute and for intra-particle
diffusion model is better than the other two models were adapted to the
experimental data. After 300 minute adsorption of nickel comes 36% of total
adsorption and cadmium adsorption comes 68% total adsorption that was
showing that cadmium adsorption is much more rapid and balance Ni.
Reference site: https://sites.google.com/site/atashnezhadamin/biodegradation‐
and‐environmental‐remediation
3. Accepted and articles
submitted
Author(s) and title 1"Suface adsorption of Nickel heavy metal in presence of Cadmium on
brown alaga has been processed in sea of Omman along with study of
balancing model"
Mohammad Khajaviana,*, Ahmad Hallaja, Nasrollah majidianb
a* Tehran north Branch of Azad Universityn faculty of chemical engineering, Email:
mohamadkhajavian@yahoo.com, , Tel: +98 912 372 7022
a Tehran University faculty of Chemical Engineering ,
Email: hallaj@ut.ac.ir , Tel: +98 919 648 0357
b Tehran north Branch of Azad University faculty of Chemical Engineering ,
Email: n_majidian@iau-tnb.ac.ir , Tel : + 98 912 344 7479
2"Suface adsorption of Nickel heavy metal in presence of Cobalt on
brown alaga has been processed in sea of Omman along with study of
balancing model"
Payam Ghelichi a,*, Mohamad Khajavian a,, Ahmad Hallaj Sani b, Nasrollah Majidian c
a,* Tehran north branch of Azad Universityn faculty of chemical engineering Email
:payam_gh273@yahoo.com, Tel: +98 912 243 7366, a Tehran north branch of Azad University
faculty of chemical engineering, Email: mohamadkhajavian@yahoo.com, Tel: +98 912 372 7022
b Tehran University faculty of Chemical Engineering, Email: hallaj@ut.ac.ir, Tel:+98 919 648
0357, c Tehran north Branch of Azad University faculty of Chemical Engineering, Email:
n_majidian@iau-tnb.ac.ir , Tel : + 98 912 344 7479
Language English
Accepted place Journal of Applied Sciences
Acceptance letter for article 1: No.67567-JAS-ANSI , 2 : No.67568-JAS-ANSI
certifications
GRE -
GMAT -
Certifications of language knowledge TOEFL iBT, 110 (Test Date: 27 Jun. 2015)
Work experience, stages,
studies abroad
• Date (from – to) Feb 2011 to Sep 2012
• Name and address of PFA (Petro Farayand Arya)
firm/university Website: http:// www.pfa.co.ir
• Type of business or sector EP Contractor in Oil & Gas,
fields
• Type of employment Full Time
4. • Main activities and responsibilities Position: Process expert
Project: Gas injection unit
Task, Responsibilities and Activities (as Process Expert):
Basis of Design
Process Simulations ( by hysys software)
Process Flow Diagrams
Heat and Material Balance
Equipment List
Equipment Sizing and Calculations
Equipment Datasheets
Piping and Instrumentation Diagrams
Material Selection
Alarm and Trip Settings
Line List
Coordination and input to other disciplines
Other various process studies and reports
Pipe Sizing and Calculations
Position: Safety Expert
Tasks and Responsibilities and activities (as Safety Expert):
Hazardous area classification
Design of firewater systems
Fire radiation calculation based on TOTAL specification (GAS-SAF-253)
Preparing material requisition (MR) and material take-off (MTO) for safety equipment
Fire Proofing for oil and gas plant
Firefighting calculation
Design sprinklers (by pipe net software)
5. .
Personal skills
and competences
Mother tongue Persian
Other language(s)
English
• reading Excellent
• writing Excellent
• speaking Good
Social skills and competences match -developed and proven ability to work in a multicultural and multinational team
environment
Excellent communication, presentation, negotiation and ability to interact effectively
with people at all levels. I mostly prepare presentations for our meetings
• Date (from – to) Sep. 2014 to March 2015
• Name and address of DPS (Darya petro sazeh)
firm/university Website: http://www.daryapetrosazeh.com/
• Type of business or sector Specializes in water and wastewater EPC projects
• Type of employment Full time
• Main activities and responsibilities Project: Water treatment by Reverse osmosis method
Tasks and Responsibilities (as Process Expert):
Process Flow Diagrams
Equipment List and Line List
Equipment Sizing and Calculations (sand filter, carbon filter, tank, pump…)
Equipment Datasheets
Piping and Instrumentation Diagrams
Material Selection
Determine number and type of membrane in Reverse Osmosis plant by ROSA
software
Calculations for Chemical injection by Avista software (chlorination, …)
Calculation for Antiscalant, acid, Caustics, chlor and … injection
Dosing pump flow rate calculation for chemicals
6. A highly motivated one and organized and methodical with excellent time
management.
Organisational skills
and competences
Ability to coordinate multiple tasks and bring projects through to successful conclusion.
Remains calm and focused under pressure and works well within strict deadlines.
A committed team player, able to motivate and inspire others and work in a cohesive
team with decision making and problem solving. .
Project management skills for medium and pilot scale projects including planning
evaluation, organization, leading, supervision, decision-making, monitoring, adjusting
plans to accommodate changes and update situations and priorities
Technical skills
and competences
Process Simulation and Modeling:. Aspen Hysys, ROSA( water treatment by RO)
/ HR Department at PFA CO and DPS Co
Hydraulic Calculation: PipeNet / Training by myself.
Chemical Injection: AVISTA /HR Department at DPSCo.
Math Works: MATLAB / Training by myself
Drawing Software: AutoCAD /Training by myself
Office Software: Word, Excel, PowerPoint & Outlook /Training by myself
Other skills and competences Football and Swimming
Running in the park or outdoor space
Additional information References:
Dr. Ahmad Hallaj sani Dr. Nasrollah Majidian
Professor at University of Tehran Professor at Azad University of
Tehran
College of Engineering, University Tehran north branch, Mirdamad Ave.
Tehran , Iran Tehran, Iran
Tel.: (+98)19 6480357 Tel.: (+98) 912 344 7479
E-mail: hallaj@ut.ac.ir E-mail: n_majidian@iau‐tnb.ac.ir