Passo a passo a montagem da abóbora

1. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
View of completed model
Assembly Instructions : Nine A4 sheets (No. 1 to No. 9)
Assembly Instructions
Glue
Mountain fold(dotted line)
The glue spot(colored dot)
Make a mountain fold.
shows where to apply the glue.
Valley fold(dashed and dotted line) Glue spot(Red dot)
Make a valley fold. Glue parts with the same number together.
Scissors line(solid line) Glue spot(Green dot) * Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
Cut along the line. Glue within the same part.
Cut in line(solid line) Glue spot(Blue dot)
Cut along the line. Glue to the rear of the other part. *Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
Scissors, set square, glue(We recommend stick glue), pencil, used
Tools and materials ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley Before starting assembly :
Assembly tip fold lines and make sure rounded sections are nice and stiff. Writing the number of each section on its back side before
Indicates where sections should
be glued together.
cutting out the sections is highly recommended.
Glue, scissors and other tools may be dangerous to young children (* This way, you can be sure which section is which even after Indicates where to insert sections.
Caution so be sure to keep them out of the reach of young children. cutting out the sections.) Do not glue the sections together.

2. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Base assembly 1 Base assembly 2
*Gently shape the curve.
Base reinforcement Fence assembly
*Fold along fold lines.
*Make two.
*Attach in an appropriate position.
*Glue together and then cut out shapes.

3. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Decorating the base Decoration stand assembly
*Apply a small amount of glue to the rim with
*Glue together and
a toothpick or similar tool.
then cut out shapes.
Interior assembly 1
*Attach in appropriate position,
without obstructing the flaps.
*Glue along the outer edge. *Attach reinforcements and assemble.

4. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Floor assembly *Attach in appropriate position,
without obstructing the flaps.
Front view
Rear view
*Attach reinforcements and assemble.
Crosspiece assembly Interior assembly 2
*Make two.

5. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Pillar assembly
*Glue together and
then cut out shapes.
*Glue together and
then cut out shapes.
*Make two.
Interior assembly 3

6. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
*Align the parts and glue together.
Exterior assembly 1
Rear view
*Glue along
the center guide.

7. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Exterior assembly 2

8. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
*Glue together and then
cut out shapes.
Pole assembly

9. Halloween house : Assembly Instructions © Canon Inc. © Ohkuma Mitsuo
Character assembly example Place characters and decorative parts as you wish.
Example
*Apply a small amount of
glue to the rim with a toothpick
or similar tool.