NATIONAL RENEWABLE ENERGY AND ENERGY EFFICIENCY POLICY (NREEEP) FOR THE ELECT...
Okuhlaza Energy Motion sensor led tube
1. Motion sensor LED tube
18w Motion sensor LED tube T8
Description:
Motion sensor LED is an intelligent
LED tube that can be automatically
dimmable by inducting the thermal
radiation from body or the car in
order to save more energy, and is
widely used for underground parking,
warehouse, tunnel lighting and other
places.
Specification:
Input voltage AC85~265/50~60HZ
Rated power 18watts
Min power 3watts
Color temperature 5500-6500k(frosted cover)
Cover type Frosted/clear/stripe
Base type G13 medium Bi-pin
Dimension D26*L1200mm
Luminous flux 1650lm(frosted cover)
Inductive beam angle 120°
Inductive distance 6~10meters
Inductive overtime 25~30s(factory set)
Reaction time 0.5s
Power factor 0.95
Work temperature -20℃~55℃
Remark:
Inductive overtime can be customized according to your requirements.
2. How it works?
When the car or a person enters in the sensor area, the infrared LED tube will be full light, the power will
be 18watts,then,lasting lighting for 30seconds,then,becoming dark, and the power will be 3watts after
the motion is from the sensor area.
Remark: motion sensor led tube is not workable in the fixture with Cover.
(workable) (unworkable)
3. Installation guide
Warning: risk of electric shock! Ensure that the power supply is off when wiring sections
of this device. This device is to be installed by a qualified electrician or technician in
accordance with all relevant local codes. Please read this user guide completely prior to
installation and please pre-plan the installation.
Note: please remove Bi-pin shipping protectors from end of tubes prior to installation
Unpacking
1. Unpack and carefully examine the product
2. Report any damage and save all packing materials if any part is damaged during transport
3. Do not attempt to use this apparatus if it is damaged
Before you start: Installation of your new LED tube is simple, but requires a basic knowledge of
wiring (as shown below).if you do not feel comfortable with this type of wiring, Okuhlaza Energy
would recommend consulting a qualified electrician.
Note: please ensure that power is disconnected from fitting before installing LED tube
Wiring with Magnetic ballast
For a single tube, the magnetic ballasts do not need to be removed, if the installation has multiple
tubes, then the ballast must be removed, to maximum energy saving, it is recommended to always
remove the ballast, the preheat/starter lamp should be removed when used with an LED tube
4. Wiring with Electronic Ballast
You should not use an LED tube with electronic ballast. Remove or bypass the electronic ballast prior
to installation, to avoid damage to the LED tube.