2. Refinishing is a tedious task to do that is why a lot of
homeowners would rather hire a cleaning company to do the job
for them. However, it is essential that homeowners refinish their
hardwood floors themselves. They should realize that the joy of
seeing the same result as professional does and at the same time
save a considerable amount of money is an investment well
spent. Refinishing does not require rocket science to get the job
right, all you need to do get the right tools and pay close
attention to details and set a time to do this job.
VacuumCleanerReviewss.Com
3. The first step is to clear all furniture, carpet and area rug
out of the room. This way, it will be easier to do
cleaning, sanding and refinishing. Furthermore, by taking
away the stuff in your room, you can prevent damaging
your furniture and carpet and your job will get faster and
easier.
VacuumCleanerReviewss.Com
4. Next is to sand off stains and stubborn spots on the floor using a sander
and sandpaper. When sanding, plan ahead where’s the best place to
start and which direction you’re going to end. If possible, start from
one end of the room towards the front door or backdoor. See to it that
you won’t miss any dull spot. Moving from one direction to another is
not going to make your job any easier. After sanding, use a broom stick
to clear any debris on the floor and then do vacuum cleaning right
after. Your wooden floor should look beautiful and shiny.
VacuumCleanerReviewss.Com
5. Before you start refinishing, prepare the stain beforehand. Do
this by stirring the stain first. Use a clean stick to stir and make
sure you stir it thoroughly. You will know that the mixture is
ready when there are no bubbles coming out of the mixture. Air
bubble in your mixture can cause mottled outward show on the
floor.
VacuumCleanerReviewss.Com
6. Now that the stain is ready. Use either a brush or a clean cloth to
apply. Use a brush if you wish to make it darker, and use a cloth if
you want to apply the stain lighter. After you have stained all
parts of the floor proceed on to the final step.
VacuumCleanerReviewss.Com
7. The next and final step is to seal the stained floor. Use a standard size
roller in applying the sealant on the floor. When applying, follow the
direction of the wood grains so that it will look beautiful. Apply a thin
layer of sealant but make sure it is evenly thin on all areas of the floor.
Again, see to it that you won’t miss a spot. Move your furniture back in
place when you’re sure enough that the floor is completely dry.
VacuumCleanerReviewss.Com
8. You have to be careful in putting back the stuff in place. See to it
that you will not drag them when moving. There’s a good chance
that you will scratch the newly finished floor. Ask someone to
help you lift the furniture and appliances back in place.
VacuumCleanerReviewss.Com